Gear Workshop rules
Calibrate every device
Fit the offered gears to the shafts until each windmill, pump or lift meets its marked direction and speed. Clear all jams as well. An arrow shows direction; ½× means half the baseline motor speed and 2× means twice that speed.
Choose a shaft and fit a wheel
Tap a shaft to select it, then choose one of the large gear buttons below the workbench. The numbers are tooth counts. Select Remove to leave that shaft empty. Motor and output wheels marked fixed cannot be changed. Changing one offered wheel is one move; selecting a shaft is free.
Keyboard users can Tab to a shaft and activate the fitting buttons with Enter or Space. Hints identify an actual fitting choice or belt change from the current state. Undo restores both layout and move count.
Mesh and speed
Gears only mesh when their pitch circles touch on the same face. A gap cannot transmit motion; overlapping circles jam the connected shafts. Each external mesh reverses direction. Angular speed changes in inverse proportion to tooth count: an 8-tooth input driving a 16-tooth output makes the output turn at half speed in the opposite direction.
Intermediate idlers affect their own speed, direction and reach, but their tooth counts cancel from a simple train's endpoint ratio. A compound wheel is different: its brass front face and teal rear face share one shaft. Both turn together, allowing a different tooth count to drive the next part of the train.
Belts and closed loops
The offered belts connect raised pulleys on their shafts. An open belt preserves direction; a crossed belt reverses it. Their pulley radii follow the driving wheel sizes, so size still changes the speed ratio. Use either the belt control on the bench or its large button below.
An odd closed loop of external meshes cannot continuously turn. Two motors connected to the same train must also agree on direction and ratio. The workshop marks these conflicts red and stops that component. Removing an unnecessary wheel can be the right move.
Progress and results
Three stars match the optimal move count. Up to two extra moves earn two stars, and completing a machine earns one. Each machine keeps its best move count and stars on this device. A working device can still have the wrong direction or speed; it counts only when its specification matches.
The result appears after the fitting and test-run feedback. Close it and use View result to recover the next-machine button. Reduced motion stops continuous wheel animation without changing the mechanical rules, hints or score.
Frequently asked questions
Do extra idler gears change the final speed ratio?
In a simple train, intermediate sizes cancel from the endpoint ratio. They still affect spacing, their own speeds and the output direction.
What is a compound gear?
Two toothed faces on one shaft share the same angular speed. Taking motion in on one face and out on the other changes the overall ratio.
Why are the gears jammed?
Pitch circles may overlap, an odd closed mesh loop may demand contradictory directions, or connected motors may disagree. Change or remove a gear, or switch a belt.
Last updated 2026-10-28